|
| | Install with Tubolite inflated to 0.5 bar. When inflating to this value, make sure that the valve is pointing to the inside of the ring.
lighter and more durable thanks to the use of an innovative material.
Twice as resistant to puncture in the needle-pressure test.
Can be easily patched with Tubolit patches.
Can be used in jackets where there is a sealant.
Holds air as well as a conventional inner tube.
Slightly better resistance in the puncture test compared to a conventional inner tube.
S-TUBO has a removable valve and thinner wall for better storage than the stock inner tube. So it easily fits in any pocket. The weight stops at 45g for the 29 inch variant and the durability is still on par with the classic inner tube.
Tubolite can be used with extension valves.
Tubolite MTB can only be used with disc brakes. Tubolit Road can be used on the road with both rim and disc brakes. Tubolit Road has passed the DIN4210 test (15 minutes braking with 10x10 sec interruptions) on both aluminium and carbon rims.
In the test when braking continuously until a puncture occurred, Tubolit did not lose explosive pressure like a conventional tube, but there was a slow puncture.
The rolling resistance of the Tubolit MTB is 4.6W lower at a speed of 28.8 km/h than the conventional tube.
The rolling resistance of Tubolit Road is 2.3W lower at a speed of 28.8km/h than that of the classic inner tube.
The maximum and minimum pressures are governed by the limit of the tire used.
Install with Tubolit inflated to 0.4 bar
Tubolit can be used on other wheels if they have the same diameter and width.
Tubolit can be temporarily inflated with CO2, but it is recommended to deflate it immediately after milking and inflate it with conventional air.
In stock | 27,90 €
|
